Prefiltering is your friend

Intake of an Aquaclear HOB with an adapter and prefilter sponge. Photo by the author.

Nearly a decade ago, I posted about the advantages of prefiltering your filter, which is simply utilizing some form of mechanical filtration on your filter’s intake inside the tank. The filter intakes on all of my tanks have cylindrical sponges on them, just like in the photo above. Why?

Below are five good reasons:

  • Lessens the filtration demands of your filter – trapping more detritus and other waste BEFORE it gets into your filter reduces the mechanical filtration effort of the filter. 
  • Reduces filter maintenance frequency – keeping detritus out of your filter reduces the frequency of cleaning the filter.
  • Reduces filter cleaning time – cleaning time required for the filter components can be reduced when they’re less dirty. 
  • Protects fry from the filter – employing some type of external prefilter mechanism will keep fry from getting sucked into the filter. I say external here because some filters (e.g., Oase’s Biomaster canister) contain internal prefilters. These are really just sponges around the intake tube inside the filter, which provides enhanced mechanical filtration internally. 
  • Reduces the intake of sand (for tanks with sand substrates) – sponges and similar mechanical media can be effective in trapping sand inside the filter, but using a prefilter on the intake can potentially prevent sand from ever reaching the inside of the filter.

I encourage you to consider prefiltering your intake. You will notice a difference in your filter, especially with heavily populated and/or planted tanks. 

 

2 thoughts on “Prefiltering is your friend”

  1. Hi. Useful site, congratulations!
    My LFS advised against prefiltering an FX4 because they say it stresses the motor … even if one is cleaning it once a week. What do you think of that?

    Reply
    • Thank you, Deep.

      I think prefiltering can safely be done without compromising motor integrity in canisters. I don’t use Fluval canisters, but I prefilter my other canisters without issue.

      Prefiltering comes in all shapes and sizes, from panty hose to sponges. When using the latter, I do think it is important to consider sponge density (ppi). Higher density sponges can restrict flow, especially as they clog. However, if you’re just wanting to catch the larger pieces of detritus and other debris, a low-density sponge should not provide enough restriction to impair a motor. Most canisters come with flow controls, which would serve the same function as a partially clogged sponge. The motor doesn’t throttle down when the flow control is implemented, yet the flow is restricted, nonetheless. Physically, this is no different than flow being restricted by a prefilter. I can’t speak for the FX4 specifically, but I can say that prefiltering an external canister can be done just fine without compromising the motor. As always, I never condone performing any modification which might compromise a filter or its warranty, so proceed at your own risk.

      Reply

Leave a Comment