
Back in November last year, I posted about some changes I was making with my show tanks. In that post, I mentioned custom tanks I had ordered.
I received the new tanks this past Friday and already have one on the stand (see photo at top). Like I mentioned in the post linked above, I had these tanks custom made with the same footprint as a standard 75g (48.5″ L, 18.5″ W, 21″ h), but I had them made shallower at 12 inches. Thus, the dimensions of these tanks are (48.5″, 18.5″, 12″).
I keep mostly lamprologines from Lake Tanganyika (shellies and julies), which don’t venture up into the water-column very often. Therefore, there is no reason to have a deeper tank.
As you can see, the tanka have black silicone, which I prefer, and a black back. The glass is also quite thick at 1/2 inch, thicker than standard 75g glass tanks.
I had the tanks pre-drilled in the bottom, but unfortunately the manufacturer drilled the holes too close to the rear of the tank. The holes were too far to the rear for my tank stands. The bulkheads would not fit. That left me with three choices – 1) carve out some of the support of the stands to accommodate the bulkheads, 2) get new stands, or 3) drill new holes. I chose #3 and, as you can see in the photo above, I drilled the holes in the back. Tank floor space is more valuable to me, so putting the holes in the back actually gives me the flexibility I wouldn’t have had by redrilling holes in the bottom. So, if you overlook the two additional points of failure caused by having the two holes in the bottom that I had to plug and seal, it works out fine.
Yes, I could have simply plugged the holes and run the filter hoses up over the back of the tank. However, the tank has glass “ledges” that run the length front and back (see photo below), which are to hold the polycarbonate tops I also had made. Running the filter hoses over the back would have meant creating some kind of customized intake/outtake assemblies because of the glass ledges. No standard canister filter intakes/outtakes would fit on these tanks.

The polycarbonate tops are seated on the ledges in the photo below. These tops are similar to what you see in many fish stores that staff lift up and away to feed and do tank maintenance. The photo below shows a top view of the same tank above and at top with the two polycarbonate pieces. Note the finger holes. I have not removed the protective paper covering the polycarbonate, but they are clear polycarbonate. You don’t use acrylic for this because the acrylic will bow over time.
